How to use these calculators
- Open the calculator that matches the experiment or circuit you are planning.
- Enter the values you already measured or were given. Leave unknown fields blank — Ohm’s law in particular expects exactly two of the four quantities.
- Read the result table, including the units. Download a text copy if you want to keep the numbers beside a lab notebook photo.
What you can calculate here
These three tools are meant to sit next to the kind of backyard and classroom projects already published on this site — foil-and-LED circuits, marshmallow catapults, and other low-voltage or mechanics activities. They are not a general “unit converter” collection and they are not a substitute for a full physics or electronics package.
The Ohm’s law calculator solves the familiar pairing of V = I × R with the power relations P = V × I, P = I²R and P = V²/R. You type any two of voltage, current, resistance and power; the other two are found from those identities. Unit menus let you enter milliamps or kilohms without converting on paper first.
The projectile motion calculator uses the constant-gravity, no-drag model: a launch speed, an angle in degrees, an optional height above the ground, and a value of g (9.80665 m/s² or 32.174 ft/s² unless you type your own). It reports time of flight, time to the peak, maximum height above the ground and above the launch point, range, and the speed and angle at impact. That is the same model used to discuss a catapult or a ball tossed across a lawn when air resistance is being ignored.
The LED resistor calculator applies Ohm’s law to one practical job: sizing a series current-limiting resistor. It takes the supply voltage, the LED forward voltage, the desired current, and how many LEDs you plan to wire in series (and how many identical strings in parallel). It then names the exact ohm value, the nearest E24 and E12 preferred values, a safer E24 pick at or above the exact value, the actual current through that safer resistor, and a wattage suggestion with a twofold dissipation margin.
Worked example
Suppose you are following the site’s aluminium-foil LED activity with a 9 V battery, a typical red LED (take 2.0 V as a starting point if you do not have a datasheet) and a 20 mA target. The LED resistor tool gives an exact resistor of 350 Ω and will suggest a 360 Ω E24 part as the safer standard value, with the current a little under 20 mA. Separately, if a marshmallow leaves a catapult at 8 m/s at 40° from a rail 0.3 m above the grass, the projectile calculator will give you an expected range and hang time under the no-drag model, which you can compare with a tape-measure result and then talk about why a real marshmallow falls short of that number.
Limitations
- All three tools run locally in your browser. They will not see a sensor or a power supply; you still have to type the measurements.
- Ohm’s law here is for a steady DC resistive load. It does not model AC impedance, motors starting up, or a battery’s internal resistance unless you include that resistance yourself.
- Projectile results ignore air resistance, Magnus effect and a rotating Earth. A light ball, a foam rocket or a marshmallow will travel less far than the vacuum result.
- LED forward-voltage presets are typical values, not a rating for the part in your hand. Always prefer the datasheet, and never drive an LED without a resistor or a constant-current source.
- No payments, no accounts, and no invented user counts or review scores appear on these pages.
Related reading on this site
- Build a Simple Circuit with Aluminum Foil and LED Lights
- Make a Marshmallow Catapult and Study Projectile Physics
Frequently asked questions
Do these calculators upload the numbers I type?
No. Each calculator runs with JavaScript in this browser tab. There is no account and no form that sends your inputs to The Backyard Scientist’s server.
Which calculator should I open first?
Use Ohm’s law when you already know two of voltage, current, resistance and power. Use the LED resistor tool when you are choosing a current-limiting resistor for a simple LED circuit. Use projectile motion when you want range, hang time or peak height for a home catapult or ball toss under the no-air-resistance model.
Are the results exact enough for school work?
The formulas are the standard textbook relations, and the worked examples in each page use values you can check by hand. Rounding in the display may differ from a teacher’s preferred number of significant figures, so copy the full-precision figure in parentheses when you need it, and use the gravity or forward-voltage value your assignment specifies.
Can I use these as a safety or wiring guide?
No. They are study and planning aids for classroom and backyard experiments. They do not replace a datasheet, a wiring diagram, or adult supervision around power supplies, batteries and moving projectiles.
Do I need to install an app?
No. A current mobile or desktop browser with JavaScript enabled is enough. After the page has loaded, the calculators keep working even if you go offline.
Why is this under /tools/calculators/ and not /calculators/?
These pages are static files in a tools subdirectory so they never overwrite the WordPress site. The address /calculators/ already redirects to the homepage, so this experiment lives at /tools/calculators/ only.