Area ConverterA free tool on thebackyardscientist.com

Area converter – sq ft, sq m, sq yard, gaj, acre, hectare

Ek area value daaliye aur sq ft, sq m, sq yard/gaj, acre, hectare dekhiye. Bigha aur guntha is page par nahi hain — unke liye land converter kholen.

Area unit converter (sq ft, sq m, sq yard, acre, hectare)

Convert area units without mixing them up with bigha

This converter exists because the plot-area page starts from two sides of a rectangle, and sometimes you already have an area — a brochure that says “1,200 sq ft super built-up”, a notice that says “0.25 acre”, a drawing titled in square metres — and you simply need the other units. It converts between square feet, square metres, square yards, gaj (taken as 9 sq ft), acres and hectares. It deliberately does not convert bigha, guntha, ground or cent, because those units change by state and already live on the land-converter tool on this site.

Worked example: 1,000 square feet

1,000 sq ft ÷ 10.76391 = 92.903 square metres. In square yards or gaj that is 1,000 ÷ 9 = 111.111. In acres it is 1,000 ÷ 43,560 = 0.022957 acres. In hectares it is 0.009290 square hectometres, written as 0.009290 ha. Type 1 hectare in the other direction and you should see 10,000 m² and 107,639 sq ft. If any of those identities fail, the page is wrong; they are the test cases used when the tool was built.

Super built-up, built-up and carpet are not unit conversions. They are different definitions of “what was measured”. Converting 1,000 sq ft of super built-up into square metres does not turn it into 92.9 m² of carpet. Read the brochure’s definition before you treat the converted number as floor you can walk on.

FromSquare metresSquare feet
1,000 sq ft92.9031,000
1 acre4,046.8643,560
1 hectare10,000107,639

Hindi mein

1,000 वर्ग फुट = 92.903 वर्ग मीटर = 111.11 गज = 0.02296 एकड़। बीघा-गुंठा यहाँ नहीं हैं — वे लैंड कन्वर्टर पर राज्य के हिसाब से बदलते हैं।

Why gaj equals square yard here

In much of North India a gaj is used as another name for a square yard (9 sq ft). Some localities historically used a slightly different linear gaj. If your sale deed defines a gaj that is not 9 sq ft, do not use this row — use the land converter or the deed’s own note. Transparency about that choice is the difference between a helpful converter and a confident mistake.

How to use this page

  1. Enter the measurements you actually took, in one unit system at a time.
  2. Read every converted figure on the card; they all come from the same raw number.
  3. If a figure will be used on a sale deed, cross-check it against the land-record unit that document uses.

For village units such as bigha, guntha and gaj-by-state, use the existing land converter instead of this page. This tool stays with rectangular plot geometry and SI / imperial area units so the two pages do not impersonate each other.

Factors: 1 sq ft = 0.09290304 m², 1 sq yd = 0.83612736 m², 1 acre = 4,046.8564224 m², 1 ha = 10,000 m², all from the international yard and pound agreement / SI definitions.

A note on precision

The card prints several decimal places so you can see that the conversions are consistent, not because a house plot is known to the nearest square centimetre. A tape stretched on a hot afternoon expands a little; a wall that is “30 ft” on a brochure may be 29 ft 8 in on the ground. Use two decimals for square metres when you are talking to a designer, and stop pretending that 0.027547 acres is more honest than “about three hundredths of an acre”. What matters is that every unit on the card describes the same physical rectangle.

If length and width were measured along a slope, the saleable plan area is the horizontal projection, which is slightly smaller. Surveyors correct for that. A garden calculator does not. For anything that will be registered, pay for the survey rather than leaning on a webpage.

Frequently asked questions

1000 sq ft kitne sq m?

92.903 m².

1 acre kitne sq ft?

43,560.

Gaj?

Treated as 9 sq ft / 1 square yard.

Bigha kyun nahi?

It varies by state; see the land converter.

Super built-up?

A definition, not a unit. Converting it does not produce carpet area.

1 hectare?

10,000 m² or 107,639 sq ft.

Unit conversion only. Local deed units that differ from these SI / imperial identities are not guessed here.